Command: himem
HIMEM is the High Memory Manager.
HIMEM has to be loaded in CONFIG.SYS / FDCONFIG.SYS.
HIMEM is out of date. You should use HIMEMX or JEMMEX instead.
Syntax:
HIMEM [/MAX=####] [/METHOD:xxx] [/HMAMIN=n] [/NUMHANDLES=m]
[/TESTMEM:ON|OFF] [/VERBOSE] [/NOABOVE16] [/X] [/LOG]
Options:
/MAX=##### Limit memory controlled by HIMEM to #####K.
/METHOD:xxx Specifies the method to be used for A20 handling.
Possible values for xxx:
ALWAYSON Assume that A20 line is permanently ON
BIOS Use BIOS to toggle the A20 line
FAST Use port 92h, bypass INT 15h test
PS2 Use port 92h, bypass PS/2 test
KBC Use the keyboard controller
PORT92 Use port 92h always
/HMAMIN=n Specifies minimum number of Kbs of HMA that a program
must request to gain access to the HMA (default: 0Kb).
/NOX2MAX32 Do not limit XMS 2.0 free/avail. memory report
to 32M-1K
/NUMHANDLES=m Specifies number of XMS handles available (def: 72).
/TESTMEM:ON|OFF Performs or skips an extended memory test (def: OFF).
/VERBOSE Gives extra information during installation.
/NOABOVE16 Do not use INT 15h function E801h to detect > 64M.
/X Do not use INT 15h function E820h to detect > 64M.
/X2MAX32 Limit XMS 2.0 free/available memory report to 32M-1K
(default).
/LOG Logs the driver activity to a log file.
/? Shows the help.
Comments:
HIMEM requires a 80386+ CPU. EMM386 can be loaded after this
driver. Load HIMEM as DEVICE=HIMEM.EXE in CONFIG.SYS (although
it is an ".exe"-file!
HIMEM has to be loaded in CONFIG.SYS / FDCONFIG.SYS.
Examples:
IN CONFIG.SYS / FDCONFIG.SYS:
device=c:\fdos\bin\himem.exe
device=c:\fdos\bin\emm386.exe
See also:
config.sys
devload
(emm386)
fdconfig.sys
(fdxms)
(fdxms286)
himemx
jemm386
jemmex
xmgr
------------------------------------------------------------------------------
Copyright (C) 2004 Robert Platt, updated 2011 by W. Spiegl.
This file is derived from the FreeDOS Spec Command HOWTO.
See the file H2Cpying for copying conditions.