Command: display
DISPLAY loads console codepage management capabilities.
Syntax:
DISPLAY devicename[:]=(hardwareType,[n|(n1[,n2]...)],[m|(m,p)])
[/V] [/C] [/NOHI]
Options:
devicename A valid device name (which is ignored in this version).
Use any (such as CON).
hardwareType A supported hardware type label (such as EGA or VGA)
n default hardware codepage (for one hardware codepage).
It will normally be 437.
n1, n2,... Hardware codepages, if more than one (usually you'll have
to use third party ARABIC/HEBREW drivers).
m Number of buffer for prepared codepages (1 by default).
p Extra hardware-specific parameter.
/C ExClusive: does not load if DISPLAY is already present.
/NOHI Disables usage of XMS memory for prepared codepages.
/V Verbose: extended information.
Comments:
Supported hardware:
VGA VGA adapters. 3 subfonts will be used in any case EGA adapters.
EGA Automatically determine the number of subfonts to be used.
EGA 14 Force to use two sub-fonts (8x8 and 8x14).
EGA 8 Force to use only one sub-font (8x8).
LCD LCD adapters (same as EGA 8).
For all the adapters above, the parameter p will try to force
the number of subfonts to be used (1=8x8, 2=8x8,8x14, 3=8x8,
8x14, 8x16) whenever hardware allows it.
CGA CGA adapter (FreeDOS GRAFTABL). Parameter p is ignored.
DISPLAY produces no EXITCODES, but provides a set of errors through
the int2Fh/AD03h function for each function. You should check it after
each unsuccessful operation.
Error code Operation Meaning
--------------------------------------------------------------
1 All Unknown function
26 Select Codepage was not prepared
26 Query No codepage was already selected
27 Select KEYB failed to change codepage
27 Query Device error
27 Prepare The codepage was not found in file
29 Select Device error
29 Prepare Device error OR XMS error
31 Prepare Source file damaged OR XMS error
31 End Prepare No Start prepare found
--------------------------------------------------------------
Examples:
DISPLAY CON=(VGA,437,1)
VGA adapter, whose BIOS standard codepage is 437. 1 buffer for
software codepage is used. This is the standard for most users.
DISPLAY CON=(EGA,,2)
Graphics adapter is EGA or better, but is unknown. BIOS default
codepage is also unknown. Two buffers are required.
See also:
chcp
cpidos
graftabl
kc
keyb
keycode
keyman
klib
kpdos
mkeyb
mode
printer.sys
xkeyb
------------------------------------------------------------------------------
Copyright (C) 2003 Aitor SANTAMARIA MERINO, updated 2008
by W. Spiegl.
This file is derived from the FreeDOS Spec Command HOWTO.
See the file H2Cpying for copying conditions.